English
EN
11
Yo
u
r p
ro
d
u
c
t
h
PRE-OUT
Connect the SW output to powered
•
subwoofer.
The PRE-OUT makes it possible to use
•
the High De
fi
nition A/V Receiver as a
pre-ampli
fi
er to external power
ampli
fi
ers for some or all channels.
Connect FRONT L, FRONT R,
CENTER, SURR R, SURR L, SURR-BL,
SURR-BR and SUBW to the respective
channel input of a power ampli
fi
er or
an ampli
fi
er driving the applicable
speakers. Unlike the full range channels,
there is no power ampli
fi
er built-into
the High De
fi
nition A/V Receiver for a
subwoofer.
i
UPLOAD (MCU, HDMI), RESET
The MCU, HDMI and RESET switches
•
are meant for product service purposes.
In the unlikely event that your High
De
fi
nition A/V Receiver hangs up, you
can press RESET to restore your High
De
fi
nition A/V Receiver to normal
adjust settings.
j
IR IN
These mini-sockets accept and output
•
remote-controlled codes in electrical
format, using industry-standard
protocols, for use with “IR-repeater”
and multi-room systems and related
technologies.
This input is connected to the output of
•
an IR (infrared) repeater (Xantech or
similar) or the IR output of another
device to allow control of the High
De
fi
nition A/V Receiver from a remote
location.
IR OUT 1-2
Both IR OUT 1 and IR OUT 2 have
•
dual-features – they can act as an
infrared command repeater or stand
alone as IR OUT. Connect the High
De
fi
nition A/V Receiver’s IR IN to the
IR OUT of ancillary device. Connect
also the High De
fi
nition A/V Receiver’s
IR OUT 1 (or IR OUT 2) to another
device with IR IN feature. With this
setup, the High De
fi
nition A/V Receiver
acts as an “IR-repeater” allowing the
device connected to the High De
fi
nition
A/V Receiver’ s IR IN control or
command of the other device linked to
the High De
fi
nition A/V Receiver’s IR
OUT 1 (or IR OUT 2).
As a stand alone IR OUT, connect IR
•
OUT 1 (or IR OUT 2) to the IR IN of
an ancillary device. Direct the ancillary
device’s own remote control to the
High De
fi
nition A/V Receiver’s infrared
receiver to command or control the
linked unit.
k
+12V TRIGGER OUT
The +12V TRIGGER OUT is used for
•
controlling external device that is
equipped with a +12V trigger input.
This output will be 12V when the
High De
fi
nition A/V Receiver is ON
and 0V when the unit is either OFF or
in standby. This output can drive a load
up to 150mA at 12V. (see ' Adjust
settings' > 'Settings menu' >
[Trigger
setup]
)
