DIGITAL TUNER
7
GENERAL INFORMATION
General maintenance
• Do not expose the set, batteries, CDs or cassettes to humidity,
rain, sand or excessive heat caused by heating equipment or
direct sunlight.
• To clean the set, use a soft, slightly dampened chamois leather.
Do not use any cleaning agents containing alcohol, ammonia,
benzene or abrasives as these may harm the housing.
Safety information
• Place the set on a hard and flat surface so that the system does
not tilt. Make sure there is adequate ventilation to prevent the
system from overheating.
• The mechanical parts of the set contain self-lubricating bearings
and must not be oiled or lubricated.
TUNING TO RADIO STATIONS
1.
Select
TUNER
source.
™
is displayed briefly and then the radio station
frequency, waveband and, if programmed, a preset number is
shown.
2.
Press
BAND
once or more to select your waveband.
3.
Press
SEARCH
∞
or
§
(
for AZ2035 model only:
or on the
remote control
TUNING
∞
or
§
) and release when the
frequency in the display starts running.
™
The tuner automatically tunes to a station of sufficient
reception. Display shows
during automatic tuning.
™
If a FM station is received in stereo,
STEREO
is shown.
4.
Repeat
step 3
if necessary until you find the desired station.
• To tune to a weak station, press
SEARCH
∞
or
§
briefly and
repeatedly until you have found optimal reception.
To improve radio reception
– For
FM
, pull out the telescopic aerial. Incline and turn the aerial.
Reduce its length if the signal is too strong (very close to a
transmitter).
– For
MW (AM/LW)
, the set is provided with a built-in aerial so
the telescopic aerial is not needed. Direct the aerial by turning
the whole set.
AZ 2030-35 /00
page
7
English
AZ 2030-2035/17
DIGIT
AL TUNER
B A S S RE
F L E X SP
E A K E R S
Y S T E M
BATT
LOW
A M
1Eur2030 30-01-2001 17:33 Pagina 7
