Philips AZ102C, User Manual

Power Supply 

Whenever convenient, use the power supply
cord if you want to conserve battery life.
Make sure you remove the plug from the set
and wall outlet before inserting batteries.

Batteries (not included)

1 

Open the battery door and insert 6 batteries,
type 

R-14

,

UM-2 

or 

C-cells

, (preferably

alkaline) with the correct polarity as indicated
by the "

+

" and "

–

" symbols inside the

compartment.

2 

Replace the battery door, making sure the
batteries are firmly and correctly in place.The
set is now ready to operate.

Batteries contain chemical substances, so
they should be disposed of properly.

•  Incorrect use of batteries can cause electrolyte

leakage and will corrode the compartment or
cause the batteries to burst

:

•  Do not mix battery types: e.g. alkaline with

carbon zinc. Only use batteries of the same type
for the set.

•  When inserting new batteries, do not try to mix

old batteries with the new ones.

•  Remove the batteries if the set is not to be used

for a long time.

•  Perchlorate Material-special handling may apply.

See
www.dtsc.ca.gov/hazardouswaste/perchlorate.

Using AC  power

WARNING: Always check you have
completely switched off the set, before
you change or disconnect power supply.

1 

Check if the power voltage,

as shown on

the type plate located on the bottom
of the set,

corresponds to your local power

supply. If it does not, consult your dealer or
service center.

2 

Connect the power cord to the 

AC

MAINS~ 

inlet and the wall socket.The set is

now connected and ready for use.

3 

To switch the set off completely, withdraw the
power cord from the wall socket.

4

Install the unit near the AC outlet and where
the AC power plug can be easily reached.

•

Disconnect the power cord from the wall
socket to protect your set during heavy
thunderstorms. Children could seriously injure
themselves as the free end of the cable may
still be live if only the connector is removed
from the MAINS socket at the back of the
unit.

The type plate is located on the bottom
of the set.

Helpful hints:

–

To avoid unnecessary energy consumption,
always adjust the 

Source selector

to

OFF

after using the set.

General operation

Switching on and off and selecting the
function 

1 

To select your sound source, adjust the

Source selector

to:

CD, FM

or 

AM

.

2

To switch off the set, adjust the 

Source 

selector

to 

OFF

position.

3

To switch to 

LINE IN

mode, connect an

external audio source to the 

LINE-IN

inlet.

Helpful hints:

•

The set switches to 

LINE IN

mode

automatically when an external audio source
is connected, no matter the set is in 

CD

,

FM

or 

AM

mode.

•

The 

LINE-IN

inlet is not for earphones.

Adjusting volume and sound 

Adjust the sound with the 

VOLUME

and

DBB

controls.

Power Supply

General Operation

AZ102C/S/N_37_UM_V2.0_EN  2010.4.16  17:20  Page 10