Philips AZ302S, User Manual

Problem 

–

Possible cause

• Remedy

No sound /power

–

Volume not adjusted

• Adjust the VOLUME
–

Power cord not securely connected

• Connect the AC power cord properly
–

Batteries dead/ incorrectly inserted

• Insert (fresh) batteries correctly
–

CD contains non-audio files

• Press

∞

,

§

once or more to skip to a CD audio

track, instead of the data file.

Display does not function properly / No

reaction to operation of any of the

controls

–

Electrostatic discharge

• Switch off and unplug the set. Reconnect after a

few seconds

---

,

Er 

or 

no

indication 

–

No CD inserted

• Insert a CD
–

CD badly scratched or dirty

• Replace/ clean CD, see Maintenance
–

Laser lens steamed up

• Wait until lens has cleared
–

CD-R/CD-RW is blank or not finalized

• Use a finalized CD-R/CD-RW or suitable CD

Audio disc only

Note:
Make sure the CD is not encoded with copy-
right protection technologies, as some do not
conform to the Compact Disc standard.

The CD skips tracks

–

CD damaged or dirty

• Replace or clean CD
–

Program/shuffle is active

• Quit program/shuffle mode

Note: A CD badly scratch or dirty may result in
improper operation

.

Sound skips during MP3 playback

–

MP3 file made at compression level exceeding
320kbps

•

Use a lower compression level to record CD
tracks into MP3 format

–

Disc damaged or dirty

•

Replace or clean disc

Troubleshooting

If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.

WARNING:

Do not open the set as there is a risk of electric shock. Under no 
circumstances should you try to repair the set yourself, as this will
invalidate the guarantee.