4
-2
4
-2
Dismantling of the Tuner Board
1) Loosen 1 screw " F " which location close to tuning button
as shown in figure 9 .
2) Loosen 1 screw " G " inside the back panel as shown in
figure 10.
Figure 11
Figure 10
Figure 9
F
G
I
3) Loosen 1 screw "H" ground wire inside back panel as
shown in figure 11.
4) Loosen 2 screws "I" at tuner board assembly as shown in
figure 12.
Figure 12
Figure 14
Dismantling of the Tape Deck &Tape Board
1) Loosen 2 screw " K " and remove the support sheet as shown in figure 13.
2) Loosen 4 screw " J " at tape deck as shown in figure 14.
3) Loosen 1 screw " L " to remove the tape board assembly as shown in figure 15.
J
K
L
Figure 13
Figure 15
Summary of Contents for AZ5737
