25
English
Tape Operation/Recording
Tuner
IMPORTANT!
– Recording is permissible if copyright or
other rights of third parties are not
infringed upon.
– Recording is possible only in tape deck.
Preparation for recording
1
Load a recordable tape with the open side up
and the full spool to the right.
2
Prepare the source to the recorded.
DISC
– load the disc(s)
TUNER
– tune to the desired radio station.
USB
– connect a compatible USB device.
When recording is in progress
1
Press
SOURCE
on the set or
DISC
,
TUNER
or
USB/AUX
on the remote as desired source.
2
Start to play the selected source.
3
Press
●
to start recording.
To stop recording
●
Press
7
/
0
on the set.
Disc synchro recording
1
Select
DISC
source.
●
You can record programmed tracks in the order
you want.
2
Press
●
to start recording.
Selecting another track during recording
1
Press
;
to interrupt recording.
2
Press
S
/
T
to select another track.
3
Press
;
to resume recording.
To stop recording
●
Press
7
/
0
on the set.
➜
Recording will stop.
IMPOTANT!
The making of unauthorized copies of copy-
protected material, including computer
programmes, files, broadcasts and sound
recordings, may be an infringement of
copyrights and constitute a criminal
offence. This equipment should not be used
for such purposes.
Tuning to radio stations
1
Press
SOURCE
on the set repeatedly or
TUNER
on the remote until the desired
waveband is displayed.
2
Press and hold
SEARCH
S
/
T
and release
the button.
➜
The radio automatically tunes to a station
with sufficient reception.
3
Repeat Step 2 if necessary until you find the
desired station.
●
To tune to a weak station, press
SEARCH
S
/
T
briefly and repeatedly until you have found
optimal reception.
●
For FM, extend, incline and turn the telescopic
antenna. Reduce its length if the signal is too
strong.
●
For MW, the set uses a built-in antenna. Direct
this antenna by turning the whol set.
Programming radio stations
You can store up to a total of 20 radio stations
in the memory.
Automatic programming
Press and hold
PROG
on the set for more than
three seconds to activate programming.
➜
All available stations are programmed.
➜
AUTO
is displayed and available stations are
programmed in order of waveband.
Manual programming
1
Tune to your desired station (refer to “Tuning to
radio stations”).
2
Press
PROG
on the set (
PROG/ANGLE
on
the remote) to activate programming.
➜
PROG
flashes on the display.
3
Press
í
/
ë
to allocate a number from 1 to 20
to this station.
4
Press
PROG
on the set (
PROG/ANGLE
on
the remote) again to confirm the setting.
➜
PROG
disappears.
5
Repeat the above four steps to store other stations.
●
You can override a preset station by storing
another frequency in its place.
Tuning to preset radio stations
●
Press
í
/
ë
until the desired preset station is
displayed.
AZ5836_58_P01-31_Eng
2008.3.13, 10:29
25
