1-6
GENERAL INFORMA
TION / CD PLA
Y
In-car use (connections supplied or optionally available)
Only use the
A
Y
3545 (4822 219 10033) or A
Y
3548 (3140 118 71890) car
voltage
converter (4.5 V DC, positive pole to the center pin) and the A
Y
3501 cassette car
adapter
. Any other product may damage the set.
1
Put the set on a horizontal, vibration-free and
stable surface. Make sure it is in a safe place,
where the set is neither a danger nor an
obstacle to the driver and the passengers.
2
Plug the voltage converter into the
cigarette lighter jack
(only for 12 V car
battery
, negative grounding)
, then connect
the wired end with 4.5V DC input jack on the
set.
3
If necessary
, clean the cigarette lighter jack to obtain a good electrical con-
tact.
4
Turn down the volume and connect the cassette adapter plug to LINE
OUT/
p
on the set.
5
Carefully insert the cassette adapter into the car radio’
s cassette compartment.
6
Make sure the cord does not hinder your driving.
7
Decrease the volume on the set if necessary
. Start playback
on the set and
adjust the sound with the car radio controls.
•
Always remove the voltage converter from the cigarette lighter jack-
when the set is not in use.
Note:
If your car radio has a LINE IN jack, it is better to use it for the
car radio connection instead of the cassette.adapter
. Connect the signal
lead to this LINE
IN jack and to
LINE
OUT/
p
on the set.
CD PLA
Y / FEA
TURES
Playback information
•
If a CD-Recordable (CD-R) or a CD-Rewritable (CD-RW) is not recorded
properly
,
nF dISC
is displayed, indicating that the CD
has not been
finalized. In that case, use FINALIZE on your CD
recorder to complete the
recording.
•
When playing a CD-Rewritable (CD-RW), please note that it takes 3–15
seconds after pressing
2;
for sound reproduction to start.
•
Playback will stop if you open the CD lid.
•
While the CD is read,
1
-:-
flashes in the display
.
Volume and bass
V
olume adjustment
•
Adjust the volume by using VOL
E
.
Bass adjustment
•
Press DBB to
switch the bass enhancement on or
off
y
is shown if the bass enhancement is
activated.
DBB
INSTRUCTION FOR USE
