GC4218
DIAL 1
RATTLE SPRING 2
BACKPLATE 3
BACKPLATE COVER 26
CORDSET 4
BALL SWIVEL 5
Remove
Screw A
Remove
Screws B1, B2
FILLING DOOR 6
INLAY 7
OPERATION KNOBS 8
LAMP 9
Remove
Screw A
Remove
Backplate 3, 26
DISASSEMBLY ADVICE
REPAIR INSTRUCTIONS
- Due to the high voltage of the iron, ONLY the specified cordsets must be used.
- Thermostat (Pos 116) fitted to the soleplate (Pos 23) was pre-adjusted by the
suppliers and secured by glue. To avoid mal-function of the iron,
NEVER
adjust
the thermostat.
- No information about the type number and voltage is stamped onto the typeplate.
When replacing the back plate (typeplate is at the bottom), engrave at least the type
number & voltage on the typeplate with a sharp object.
- Parts with numbers from 103 and higher cannot be ordered separately.
OPTIONAL (accessories)
- No specific issues
SLIDE UNIT 10
NEEDLE SET 11
TANK SEAL 12
HANDLE 13
SELF CLEAN BUTTONS 14
SPRAY NOZZLE ASSY 15
PUMP ASSY 16
Remove
Screw A
Remove
Backplate 3, 26
Remove
Inlay 7
Remove
Operation knobs 101, 102
Remove
Screws C1, C2
Remove
Slide Unit 103, 104
Remove
Needle set
105, 106, 107, 108, 109
Remove
Screws D1, D2
THERMOSTAT BUSH 17
WATER TANK 18
Remove
Screw A
Remove
Backplate 3, 26
Remove
Inlay 7
Remove
Operation knobs 101, 102
Remove
Screws D1, D2
Remove
Handle 13
Remove
Screws E1, E
2
Remove
Water tank 18
Remove
Screw F
SOLEPLATE COVER 19
ISOLATION PLUG 20
SOS SEAL 21
DOSING SEAL 22
SOLEPLATE ASSY 23
Remove
Screw A
Remove
Backplate 3, 26
Remove
Inlay 7
Remove
Operation knobs 101, 102
Remove
Screws D1, D2
Remove
Handle 13
Remove
Screws E1, E2
Remove
Water tank 18
Remove
Screw F
Remove
Heat shield
Remove
Screws G1, G2
Remove
Soleplate cover 19
2-4
