ENGLISH
11
Problem
Possible cause
Solution
You have not closed the
water tank lid properly.
Press the lid until you hear a ‘click’.
You have not insert
the Quick Calc Release
collector properly back
to the appliance (specific
types only).
Stop ironing and let the iron cools down for at
least 1 hour. Take out the Quick Calc Release
collector. Insert it back into the appliance and
ensure the collector is in-line with the surface
of the appliance. Push down the lever (“click”).
If the Quick Calc release tray is damaged,
contact a consumer care center in your country
(see the world wide guarantee leaflet for
contact details).
You have put a chemical
into the water tank.
Rinse the water tank and do not put any
perfume or chemicals into the water tank.
The iron does not
produce a steam
boost
You have used the steam
boost function too often
within a short period.
Continue ironing in horizontal position and
wait a while before you use the steam boost
function again.
You are ironing before the
iron gets ready
Wait until the iron is ready (the light on the
display panel stops flashing).
Dirty water
and impurities
come out of the
soleplate during
ironing.
Hard water with impurities
or chemicals has formed
flakes inside the soleplate.
Perform Quick Calc Release (specific types
only) or Calc-Clean (specific types only).
See chapter “Cleaning and maintenance”.
There is an amber
light flashing on
the handle of the
iron.
The Calc-Clean reminder
light is activated. This is
to remind you to perform
Calc-Clean.
Perform Quick Calc Release (specific types
only) or Calc-Clean (specific types only).
See chapter “Cleaning and maintenance”.
The iron leaves a
shine or an imprint
on the garment.
The surface to be ironed
was uneven, for instance
because you ironed over
a seam or a fold in the
garment.
The iron is safe to use on all ironable garments.
The shine or imprint is not permanent and
disappears when you wash the garment. Avoid
ironing over seams or folds. You can also place
a cotton cloth over the area to be ironed to
avoid imprints.
The iron makes a
lot of noise.
There is no water in the
appliance.
Fill the water in the water tank.
