Problem
Possible cause
Solution
You have put an additive in
the water tank.
Rinse the water tank and do not put any
additive in the water tank.
You have used the steam
boost function at a
temperature setting below
3
.
Set the temperature dial to a setting between
and
3
and MAX.
Water drips from
the soleplate after
the iron has
cooled down or
has been stored.
The iron has been put in
horizontal position with
water still left in the water
tank.
Empty the water tank before you store the
iron. Store the iron on its heel.
Flakes and
impurities come
out of the
soleplate during
ironing.
Hard water forms flakes
inside the soleplate.
Use the Calc-Clean function one or more
times (see chapter ‘Cleaning and maintenance’,
section ‘Using the Calc-Clean function’).
The red auto-off
light flashes
(specific types
only).
The automatic shut-off
function has switched off
the iron (see chapter
‘Features’).
Move the iron slightly to deactivate the
automatic shut-off function. The red auto-off
light stops flashing.
The blue tank
light flashes
(specific types
only).
The automatic shut-off
function has switched off
the iron (see chapter
‘Features’, section
‘Automatic shut-off
function’).
Move the iron slightly to deactivate the
automatic shut-off function. The blue tank light
stops flashing.
The iron makes a
humming sound.
The Ionic DeepSteam
function is on.
If you hear the humming sound when you iron
without steam, stop pressing the Ionic
DeepSteam trigger. The Ionic DeepSteam
function has no effect when you iron without
steam.
EnGlISh
12
Summary of Contents for Azur Ionic GC4730
