100W MAX
REQUIRED
NO
PAR38 MH
PAR38 MH
150W MAX
NO
REQUIRED
Possible lamps to be used are...
250W MAX
PAR38 INCANDESCENT
NO
OPTIONAL
Wattage
Lamping
Reflector
150W MAX
E17 MH
YES
INCLUDED
OPTIONAL
NO
PAR38 INCANDESCENT
175W MAX
100W MAX
E17 MH
YES
INCLUDED
300W MAX
R40 INCANDESCENT
NO
REQUIRED
150W MAX
R40 INCANDESCENT
NO
REQUIRED
Wattage
Lamping
Reflector
Shroud
Composite Fixtures:
Aluminum/Brass Fixtures:
Shroud
INSTALLATION INSTRUCTIONS
1. Make sure power is OFF before installing or servicing this fiixture.
2. The fixture must be mounted to a U.L. listed junction box or mounting stake. Stake #S3 & S35
may be used, or boxes #M0029, BI1, BI2, BI3, BI4, CB1, TM2H, TMC2H, or any IBH/WBH ballast boxes.
3. Thread wires through hole in stake cap, or junction box lid. Screw arm of fixture onto lid.
Lock into desired position by tightening arm locknut.
4. Connect white supply wire to white fixture wire, black supply wire to black fixture wire, and supply
ground wire to fixture ground wire. Use wire connectors (not supplied) to secure connections.
5. Attach cap/lid to stake/box, making sure not to pinch wires.
6. If fixture includes a shroud, loosen the shroud screw and remove the shroud.
7. Install specified lamp according to lamp label on fixture and/or the chart above.
8.
If using a Metal Halide lamp, fill in the lamp wattage and ANSI Code on the lamp label. The lamp and
ballast ANSI codes must match (see below chart of Hadco ballasts and ANSI Codes).
9. If shroud was included, or purchased separately, put shroud on fixture and tighten shroud screw.
* AN OPEN RATED LAMP MUST BE USED WHEN NOT USING SHROUD.
HADCO BALLAST TABLE (INFO TO BE USED TO COMPLETE HID LAMP LABEL)
Model Number
Wattage
ANSI Code
ABH/IBH/WBH
35
M130
ABH/IBH/WBH
50
M110
ABH/IBH/WBH
70
M98/M143
ABH/IBH/WBH
100
M90/M140
ABH/IBH
150
M102/M142
page 2 of 3
32000562, revision G
