Philips BDL4830QL, User Manual

BDL4830QL 

iv

Regulatory Information

CE Declaration of Conformity

We declare under our responsibility that the product is in conformity 
with the following standards: 

  EN60065:2002+A1:2006+A11:2008+A2:2010+A12:2011 (Safety 

 " J     !

  [\]]^__<_^`^ & q  " #" 

 [!

  [\]]^_{<_^`^ #  " #"  

[!

  EN61000-3-2:2006 +A1:2009+A2:2009 (Limits for Harmonic 

Current Emission)

  EN61000-3-3:2008 (Limitation of Voltage Fluctuation and Flicker) 

  EN 50581:2012 (Technical documentation for the assessment of 

electrical and electronic products with respect to the restriction of 
hazardous substances)

following provisions of directives applicable:

  2006/95/EC (Low Voltage Directive)

  2004/108/EC (EMC Directive)

  2009/125/EC (ErP Directive, EC No. 1275/2008, 642/2009 

Implementing Directive for Standby and Off mode power 
consumption)

  93/68/EEC (Amendment of EMC and Low Voltage Directive) and is 

produced by a manufacturing organization on ISO9000 level.

  2011/65/EU (RoHS 2 Directive) 

Federal Communications Commission (FCC) 
Notice (U.S. Only)

      "   
with the limits for a Class A digital device, pursuant to 
part 15 of the FCC Rules. These limits are designed 
to provide reasonable protection against harmful 
"       
      "  
and, if not installed and used in accordance with the 
instructions, may cause harmful interference to radio 
communications. However, there is no guarantee that 
interference will not occur in a particular installation. 
#"     " " 
to radio or television reception, which can be 
     ""    
user is encouraged to try to correct the interference 
by one or more of the following measures:

Reorient or relocate the receiving antenna.

#      
and receiver.

|        
circuit different from that to which the receiver is 
connected.

Consult the dealer or an experienced radio/TV 
technician for help.

|    +   
the party responsible for compliance could void the 
}    

Use only an RF shielded cable that was supplied with the display when 
connecting this display to a computer device.

         ; >   
expose this appliance to rain or excessive moisture.

THIS CLASS B DIGITAL APPARATUS MEETS ALL REQUIREMENTS 
OF THE CANADIAN INTERFERENCE- CAUSING EQUIPMENT 
REGULATIONS.

This device complies with Part 15 of the FCC Rules. 
Operation is subject to the following two conditions: 
(1) this device may not cause harmful interference, 
and (2) this device must accept any interference 
received, including interference that may cause 
undesired operation.