Philips BDL4830QL, User Manual

BDL4830QL

v

  
Notice

     "  ;    
    ;! J   ; 
together (computer, display, printer, and so on) should have the same 
power supply source.

The phasing conductor of the room’s electrical installation should have 
a reserve short-circuit protection device in the form of a fuse with a 
nominal value no larger than 16 amperes (A).

   ""        
be removed from the power supply socket, which should be located 
     

J  ; ~€        
     "  \‚ƒ%{_`^„ 
and PN-89/E-06251.

Electric, Magnetic and Electronmagnetic 
Fields (“EMF”)

1.  We manufacture and sell many products targeted at consumers, 

which, like any electronic apparatus, in general have the ability to 
emit and receive electromagnetic signals.

2.  One of our leading Business Principles is to take all necessary health 

and safety measures for our products, to comply with all applicable 
        […†  
applicable at the time of producing the products.

3.  We are committed to develop, produce and market products that 

cause no adverse health effects.

4. ‡   "      "  

    "       
available today.

5.  We play an active role in the development of international EMF and 

safety standards, enabling us to anticipate further developments in 
standardization for early integration in its products.

Information for U.K. only

WARNING – THIS APPLIANCE MUST BE EARTHED.

Important:

(A)

(B)

This apparatus is supplied with an approved moulded 13A plug. To 
change a fuse in this type of plug proceed as follows:

1.  Remove fuse cover and fuse.

2.  Fit new fuse which should be a BS 1362 5A,A.S.T.A. or BSI approved 

type.

3. &  "

#"       "  ;      
""    ƒ    

If the mains plug contains a fuse, this should have a value of 5A. If a plug 
without a fuse is used, the fuse at the distribution board should not be 
greater than 5A.

NOTE

:  

The severed plug must be destroyed to avoid a possible shock 
hazard should it be inserted into a 13A socket elsewhere.

How to connect a plug

The wires in the mains lead are coloured in accordance with the 
following code:

BLUE – “NEUTRAL” (“

N

”)

BROWN – “LIVE” (“

L

”)

GREEN & YELLOW – “EARTH” (“

E

”)

1.  The GREEN & YELLOW wire must be connected to the terminal in 

the plug which is marked with the letter “

E

” or by the Earth symbol 

or coloured GREEN or GREEN & YELLOW.

2.  The BLUE wire must be connected to the terminal which is marked 

with the letter “

N

” or coloured BLACK.

3.  The BROWN wire must be connected to the terminal which 

marked with the letter “

L

” or coloured RED.

Before replacing the plug cover, make certain that the cord grip is 
clamped over the sheath of the lead – not simply over the three wires.