User Manual BDL5545E
39
Panel saving
Choose to enable the panel saving functions to reduce the risk of the "image persistence”. Press the
SET/PLUS
button to open the submenu, and then press the
UP
/
DOWN
button to toggle between
x
COOLING FAN
- Select
On
and the cooling fan is activated all the time. Select
AUTO
and the cooling
fan will turn on/off according to the temperature of display.
Note:
The conditions of the cooling fan are low/mid/high speed at 50/58/63 °C respectively. The display
will automatically shut down if a preset critical temperature (82 °C) is reached.
x
Brightness
- Select
On
and the brightness of the image will be reduced to an appropriate level, and the
Brightness
setting in the
Picture
menu will become unavailable. Use the
PLUS
/
MINUS
button to make
selection.
x
Pixel Shift
- Select the time interval for the monitor to slightly expand the image size and shift the
position of pixels in four directions (up, down, left, and right). Use the
PLUS
/
MINUS
button to make
selection (
Off, AUTO, 10-900
seconds from current time).
IMPORTANT
: It is not recommended to keep a single static image displayed on your unit for long periods
of time. This can cause image sticking, or ghost images, which will decrease the quality of your images.
In some instances, ghost image damage can be permanent. Ghost imaging is also not covered by warranty,
so in order to avoid such issues, we strongly recommend one of the following actions
:
x
Change the picture periodically
x
Enable
Pixel shift
(See Pixel shift under Section 4.2.5.CONFIGURATION 1 MENU)
x
Use a screen saver with changing image
Serial control port
Choose to enable or disable the function of the control port.
Press the
SET/PLUS
button to open the submenu, and then press the
UP
/
DOWN
button to make
selection.
Configuration reset
Reset all settings in the
Configuration 1
menu.
Press the
SET/PLUS
button to open the submenu, and then press the
PLUS
/
MINUS
button to make
selection. Select
Reset
and press the
SET
button to restore settings to factory preset values. Press the
EXIT
button or select
Cancel
and press the
SET
button to cancel and then return to the previous menu.
Factory reset
Reset all settings in the
Picture
,
Screen
,
Audio
,
PIP
,
Configuration 1
,
Configuration 2
, and
Advanced
option
menus. Press the
SET/PLUS
button to open the submenu, and then press the
PLUS
/
MINUS
button to make selection. Select
Reset
and press the
SET
button to restore settings to factory preset
values. Press the
EXIT
button or select
Cancel
and press the
SET
button to cancel and then return to the
previous menu.
