14
EN
7 Troubleshooting
Warning
•
Never remove the casing of this device.
To keep the warranty valid, never try to repair
the system yourself.
If you encounter problems when using this
device, check the following points before
requesting service. If the problem remains
unsolved, go to the Philips Web page
(www.philips.com/support). When you contact
Philips, make sure that the device is nearby
and the model number and serial number are
available.
No power
•
Make sure that the AC power cord of the
speaker is connected properly.
•
Make sure that there is power at the AC
outlet.
•
Recharge your speaker.
•
As a power-saving feature, the speaker
switches off automatically after 15 minutes
of inactivity.
No sound
•
Adjust volume.
•
Check whether the speaker is muted.
Some buttons on the unit do not work or the
unit is not working as usual.
•
You may have activated demo mode by
accident. In this case, unplug the power
cable, press and hold and then plug
in the power cable again. Continue to
hold the button for 15 seconds until all
indicators flash to exit demo mode. If
the issue remains, repeat the operation.
Then you can power on and operate the
speaker as usual.
No response from the speaker
•
Restart the speaker.
Music playback is unavailable on this speaker
even after successful Bluetooth connection.
•
Check whether the current audio source
of the speaker is AUDIO IN. Unplug the
3.5mm audio cable.
•
The device cannot be used to play music
through this speaker wirelessly.
The audio quality is poor after connection
with a Bluetooth-enabled device.
•
The Bluetooth reception is poor. Move the
device closer to this speaker or remove
any obstacle between them.
Bluetooth cannot be connected with this
speaker.
•
The device does not support the
Bluetooth profiles required for this speaker.
•
The Bluetooth function of the device is
not enabled. Refer to the user manual of
the device to find out how to enable the
function.
•
This speaker is not in pairing mode or acts
as a slave in a group. In group mode, you
can only set up Bluetooth connection with
the master speaker.
•
This speaker is already connected with
another Bluetooth-enabled device.
Disconnect that device and then try again.
Group connection failed
•
Move slave speakers closer to the master.
•
You can only add slave speakers one by
one.
•
You cannot group more than four speakers
with the master.
•
The master speaker may have switched to
single mode.
Occasional stuttering or breaking of music
streaming during group playback
•
If you experience music stuttering or
breaking of streaming, it could be that your
home Wi-Fi network is busy. Even though
izzylink is independent from your home
Wi-Fi network, it uses Wi-Fi signals to
communicate between the speakers. Try
the following : 1) Reduce traffic on your
home Wi-Fi network, e.g. stop any large file
downloads or other content streaming on
your Wi-Fi network; 2) Reboot the Master
speaker, by unplugging it from the mains
and plugging it in again.
