2
Remove and discard the brush head. Cover
the entire handle with a towel or cloth.
3
Hold the top of the handle with one hand
and strike the handle housing 0.5
inch
above the bottom end. Strike firmly with a
hammer on all 4 sides to eject the end cap.
Note: You may have to hit on the end
several times to break the internal snap
connections.
4
Remove the end cap from the toothbrush
handle. If the end cap does not release
easily from the housing, repeat step 3 until
the end cap is released.
5
Holding the handle upside down, press the
shaft down on a hard surface. If the internal
components do not easily release from the
housing, repeat step 3 until the internal
components are released.
6
Remove the inner assembly from the
housing by fully inserting a small flat-head
screwdriver into the slot opposite the circuit
board and pry until it comes apart.
19
English
Summary of Contents for DailyClean HX3211
