9
EN
Prepare the remote control
Caution
•
Risk of product damage! When the remote control is
not used for long periods, remove the batteries.
To insert the remote control battery:
1
Open the battery compartment.
2
Insert the supplied AAA battery with
correct polarity (+/-) as indicated.
3
Close the battery compartment.
Power on
Press .
»
DCM3160
switches to the last selected
source.
Switch to standby mode
Press again to switch
DCM3160
to standby
mode.
»
The clock (if set) is displayed on the panel.
•
In standby mode, press to switch
between working mode and standby
mode.
Note
•
DCM3160 switches to Standby mode after 15 minutes
inactive.
Switch to ECO power standby mode
Press and hold for more than two seconds.
»
The red ECO power standby indicator
turns on.
•
In Eco power standby mode, press to
switch between working mode and ECO
power standby mode.
Note
•
DCM3160 switches to ECO power Standby mode
after 15 minutes in standby mode.
Switch between standby mode and ECO
p
ower
standby mode:
•
Press and hold for more than two
seconds.
Set the clock
1
In standby mode, press and hold
CLOCK
for more than two seconds to enter the
clock setting mode.
»
[24 HOUR]
or
[12 HOUR]
is
displayed.
2
Press / to select
24
or
12
hour
format, and then press
CLOCK
.
»
The hour digits begin to blink.
3
Press / to set the hour, and then
press
CLOCK
.
»
The minute digits begin to blink.
4
Press / to set the minute, and then
press
CLOCK
.
»
The set clock is displayed.
Note
•
To view clock information in working mode, press
CLOCK
.
•
If no button is pressed in 90 seconds during setting,
DCM3160
exits clock setting without saving earlier
operations.
Summary of Contents for DCM3160
Page 2: ......
