14
EN
Program radio stations
manually
You can program a maximum of 20 preset
radio stations (FM).
1
Tune to a radio station.
2
Press
PROG
to activate program mode.
»
[PROG]
(program) is displayed.
3
Press
PRESET
/
ALBUM
/ to allocate
a number to this radio station, then press
PROG
to confirm.
4
Repeat the above steps to program other
stations.
Tip
•
To overwrite a programmed station, store another
station in its place.
Select a preset radio station
•
In tuner mode, press
PRESET
/
ALBUM
/
to select a preset number.
Tip
•
Position the antenna as far as possible from TV, VCR, or
other radiation source.
•
For optimal reception, fully extend and adjust the
position of the antenna.
Select stereo/mono broadcast
For stations with weak signals: to improve the
reception, change to monaural sound.
•
In tuner source, press
OK
to select a
setting:
•
[STEREO]
: stereo broadcast.
•
[MONO]
: monaural broadcast.
Show RDS information
RDS (Radio Data System) is a service
that allows FM stations to show additional
information. If you tune to an RDS station, an
RDS icon and the station name are displayed.
1
Tune to an RDS station.
2
Press
RDS
/
DISPLAY
repeatedly to scroll
through the following information (if
available):
»
Station name
»
Program type such as
[NEWS]
(news),
[SPORT]
(sport),
[POP M]
(pop
music)...
»
RDS RT
»
RDS CLOCK
»
Frequency
Synchronize clock with RDS
You can synchronize time shown on the unit
with that on the RDS station.
1
Tune to a RDS radio station that transmits
time signals.
2
Press
RDS
/
DISPLAY
for over 2 seconds.
»
[CT SYNC]
is displayed and the unit
reads RDS time automatically.
»
If no time signal is received,
[NO CT]
is displayed.
Note
•
The accuracy of the transmitted time depends on the
RDS station that transmits the time signal.
Summary of Contents for DCM3175
Page 2: ......
