4.3 SATELLITES
The ASTRA 19.2° and Eutelsat 13° (Hotbird) satellites are activated as per the default factory
settings. Six other satellites are pre-programmed, but not activated. If you expand your reception
equipment, you can make the required settings and activations for the pre-programmed satellites
in the ‘Satellite’ menu.
Activate the desired satellite number, e.g. using the number keys
1...8
, and call up the Input
menu using the
OK
key.
(1)
Entering or amending a name
Activate the {NAME} input field using key
1
followed by
OK
.
You can select letters (upper or lower case) or numbers via the
9
or
8
key.
You can shift the input position right or left using the
*
or
+
key.
After inputting the desired name, the input field is deactivated again by pressing the
OK
key.
(2) Inputting
LO1
(3) Inputting
LO2
LO1 and LO2 are preset to 9750 MHz and 10600 MHz as default by the factory.
If the LNB-LO frequencies differ from the preset values, enter the relevant values here.
Activate using the
OK
key, enter the LO frequencies using the number keys
0
...
9
, then
confirm using the
OK
key.
Please ensure that a digital-compatible LNB is installed in your reception equipment.
(4)
Inputting the orbit position
The parameter «Orbit position» with possible values 1...4 must be stated when operating
using the DiSEqC feature.
(5) Enabling
{ON}
The selected satellite is enabled for your reception equipment.
{OFF}
The selected satellite is blocked.
4.4 INSTALLATION
4.4.1 Time offset
After switching on at the mains switch or after a power cut the time and date for the system clock
(timer) are transferred from the data received. To ensure that the time and date of the receiver
correspond to local time, a value for the deviation from standard time must be entered.
The offset value for CET summer time is {+2} hours, for CET winter time {+1} hour.
Please check or, if need be, correct the time offset value when setting up your equipment
and also when the time changes in spring and autumn.
(1)
Select using key
1
or using the
98
keys, then activate using the
OK
key and set the
desired time offset value using the
*+
keys. Confirm the modifications using the
OK
key.
N.B.:
If an incorrect time offset value is entered, programme times will be indicated
incorrectly.
'
GB
Summary of Contents for DSR 2015
Page 1: ......
