20
EN
Setup
Audio setup
[Analogue Output]
- Adjust this setting for audio output through
AUDIO OUT
.
•
[Stereo]
- Compress multi-channel Dolby digital sound to stereophonic sound output through
AUDIO OUT FRONT L/R
.
•
[LT/RT]
- Compress multi-channel Dolby digital sound to 2-channel surround sound output
through
AUDIO OUT FRONT L/R
.
•
[Multi Channel]
- Enjoy Dolby digital sound output through
AUDIO OUT
5.1 channels.
[Digital Audio]
- Adjust this setting for audio output through
COAXIAL/DIGITAL OUT
.
•
[Digital Output]
- Select a type of digital output.
•
[Off]
- Disable digital output.
•
[All]
- Support multi-channel audio formats.
•
[PCM Only]
- Downmix to two-channel audio signal.
•
[LPCM Output]
- Select the LPCM (Linear Pulse Code Modulation) output sampling rate.
Note
•
[LPCM Output]
setting is changeable only when
[Digital Output]
is set as
[PCM Only]
.
The higher the sampling rate, the better the sound quality.
•
[HDMI Audio]
- Enable or disable the audio output through HDMI cable.
[Audio Sync]
- Set a delay time for audio output when you play a video disc.
[Volume]
- Set the default volume level.
[Sound Mode]
- Select a preset sound effect.
[Speaker Setup]
- Optimize the surround effect for the connected speaker system.
•
[Front Speaker]
,
[Center Speaker]
and
[Rear Speaker]
Select
•
[Large]
when the speakers support the output of low frequency signal (lower than
120 Hz), otherwise select
[Small]
.
Select
•
[Off]
(This option is not available for
[Front Speaker]
) to mute the speaker(s).
•
[Subwoofer]
- Mute or unmute the subwoofer.
•
[Speakers Volume]
- Increase or decrease the volume level of each speaker.
•
[Speakers Delay]
- Set the delay time for each speaker.
General
Analogue Output
Digital Audio
HDMI Audio
Audio Sync
Volume
Sound Mode
Video
Audio
Preference
Stereo
Off
Night Mode
On
Speaker Setup
DVP3888K_93_UM.indb 20
3/16/2011 10:03:07 AM
