Philips FC9202, User Manual

Replace the HEPA Filter every six months.

1

Open the filter grille (fig. 26).

2

Remove the old filter (fig. 27).

3

Insert the new filter into the appliance.

4

Close the filter grille and push the bottom corners until they snap home (fig. 28).

Ordering accessories and filters

If you have any difficulties obtaining filters or other accessories for this appliance, please contact the
Philips Customer Care Centre in your country or consult the worldwide guarantee leaflet.
-

Philips filter cylinders are available under service number 4322 005 17520.

-

Super Clean Air filters are available under type number FC8030.

-

Super Clean Air HEPA Filters are available under type number FC8031.

Guarantee & service

If you need information or if you have a problem, please visit the Philips website at 

www.philips.com

or contact the Philips Customer Care Centre in your country (you will find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in your country, turn to your
local Philips dealer or contact the Service Department of Philips Domestic Appliances and Personal
Care BV.

Troubleshooting

1

The suction power is insufficient.

◗

Check if the suction power knob is in maximum position.

◗

Check if the filter cylinder is filled with dirt. If necessary, clean this filter.

◗

Check if the other filters need to be cleaned or replaced.

◗

Check if the blockage indicator has changed colour. If so, the nozzle, tube or hose may be
blocked up.To remove the obstruction, disconnect the blocked-up item and connect it (as far
as possible) the other way around. Switch the vacuum cleaner on to force the air through the
blocked-up item in opposite direction (fig. 29).

2

The appliance cannot be switched on.

◗

Check if the filter cylinder case with the filter cylinder in it has been inserted into the dust
bucket.

ENGLISH

10