Mechanical Instructions
4.
4.
Mechanical Instructions
Index of this chapter:
4.1 Service Positions
4.2 Assy/PWB Removal
4.3 Set Re-assembly
Notes:
•
Figures below can deviate slightly from the actual situation,
due to the different set executions.
•
Follow the disassemble instructions in described order.
4.1
Service Positions
First, put the TV set in its service position. Therefore, place it
upside down on a table top (use a protection sheet or a foam
cushion).
4.1.1
The Foam Bars
Figure 4-1 Foam bars
The foam bars (order code 3122 785 90580) can be used for
all types and sizes of Flat TVs. By laying the plasma or LCD TV
flat on the (ESD protective) foam bars, a stable situation is
created to perform measurements and alignments. By placing
first a mirror flat on the table under the TV, you can easily see
if something is happening on the screen.
The bars are also handy for replacing the screen.
4.1.2
The Aluminum Stands
Figure 4-2 Aluminium stands
The aluminum stands (order code 3122 785 90480) can be
used to do measurements and alignments and they are also
very suitable to perform duration tests. With these stands the
set does not take much space, has no risk of over heating and/
or falling. They can be mounted and removed quickly and
easily with use of the provided screws, which can be tightened
and loosened manually without the use of tools.
Caution:
Only use the provided screws, otherwise it is possible
to damage the monitor inside.
4.2
Assy/PWB Removal
4.2.1
Rear Cover
Warning:
Disconnect the mains power cord before you remove
the rear cover.
First, unscrew the rear cover:
1.
Remove the screws that secure the rear cover. The screws
are located at the top, bottom, left and right sides, also
there are three deeper located screws next to the stands.
2.
Lift the rear cover from the cabinet. Make sure that wires
and flat foils are not damaged during cover removal.
4.2.2
Side I/O Panel
Figure 4-3 Side I/O panel
1.
Disconnect the cable from the panel.
2.
To replace the complete bracket, remove the two fixing
screws (1) on either side of the panel.
3.
To get the panel out, push the two brackets (2) out and lift
the panel.
4.
Remove the panel.
CL 36532051_002.eps
190603
CL 36532051_001.eps
040703
2
CL 36532064_050.eps
161003
1
FTL13U_AA_AB_312278513481.book Page 17 Thursday, December 30, 2004 1:50 PM
