3139 116 19452 (ENG)
18
Disc Change
You can change the outer two discs
while the third inner disc is stopped or
is playing.
1
Press
DISC CHANGE
.
™
The CD carousel tray slides out.
2
Replace the discs in the left and right
disc trays.
• If you wish to change the inner disc
during playback, press
DISC
CHANGE
again.
™
“
DISC CHANGE
" will be
displayed.
™
The CD will stop playing.
™
The CD carousel tray will close to
retrieve the inner CD and then
open again with the inner CD
accessible.
3
Press
OPEN•CLOSE
to close the
CD carousel tray.
Selecting a desired track
Selecting a desired track when
playback is stopped
1
Press
í
or
ë
until the desired
track appears on the display.
2
Press
É
to start playback.
™
The selected track number and
elapsed playing time appear on
the display.
Selecting a desired track during
playback
• Press
í
or
ë
until the desired
track appears on the display.
™
The selected track number and
elapsed playing time appear on
the display.
• If you press
í
once it will skip to
the beginning of the current track
and play the track again.
Note:
– Pressing
í
during shuffling can only skip
to the beginning of the current track.
Searching for a particular
passage during playback
• Press and hold
à
or
á
until the
desired passage is located.
™
The volume will be reduced.
• Play returns to normal when
à
or
á
is released.
CD
Programming Tracks
Programming tracks of a loaded CD is
possible when playback is stopped. The
display will indicate the total tracks
stored in the program. Up to 40 tracks
can be stored in the memory in any
order. When 40 tracks are stored and
you attempt to store another track, the
display will show “
FULL
”.
1
Load the desired discs in the disc
trays.
2
Press
PROG
to start programming.
™
The
PROGRAM
starts flashing.
™
It will cancel any previously
selected repeat mode.
3
Press the
CD
(CD 1•2•3) or
DISC
1/2/3
button to select the disc.
4
Press
í
or
ë
to select the desired
track.
5
Press
PROG
to store the track.
• Repeat steps
3
to
5
to store other
discs and tracks.
6
Press
Ç
once to end programming.
™
The total number of tracks
programmed and total playing
time appear on the display.
Notes:
– If the total playing time is more than
“
99:59
“
or if one of the
programmed tracks has a number
greater than 30, then “
--:--
”
appears on the display instead of the
total playing time.
– If the system is reading the disc,
programming is not possible,
“
READING
” will be displayed and
followed by "
DISC X
" "
X
" is the
current read disc number.
– During programming, if no button is
pressed within 20 seconds, the system
will exit program mode automatically.
Reviewing the program
Reviewing of the program is possible
only when playback is stopped.
• Press
í
or
ë
repeatedly to review
the programmed tracks.
• Press
Ç
once to exit review mode.
pg 01-28/P78/37-Eng2
12/20/99, 2:23 PM
18
