Location of printed circuit boards . . . . . . . . . . . . . . . . . . . 1-2
Technical specification . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-1
Measurement setup . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-2
RC-5 codes. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2-3
Warnings & safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-1
Service Testprogram . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3-3
Wiring Diagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4-1
Block/Leveldiagram . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5-1
Front Board . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Tuner Board . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Audio Frequency Board (AF7) . . . . . . . . . . . . . . . . . . . . . 8
Power Board. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
3 Disc Changer Module . . . . . . . . . . . . . . . . . . . . . . . . . . 10
CD R/W Module . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Exploded view of set. . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-1
Partslist of set . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 12-3
FW-R88
/21/22/37
Published by HB 0106 Service Audio Printed in The Netherlands Subject to modification
©
3103 785 25080
CDR Mini System
CLASS 1
LASER PRODUCT
©
Copyright 2001 Philips Consumer Electronics B.V. Eindhoven, The Netherlands
All rights reserved. No part of this publication may be reproduced, stored in a retrieval
system or transmitted, in any form or by any means, electronic, mechanical, photocopying,
or otherwise without the prior permission of Philips.
SERVICING
For servicing FW-R88, the set can be divided into two parts:
1. Except for the CD-R/W module all workshops can repair the set on component level.
2.The CD-R/W module can also be repaired at component level with the help of
COMPAIR Release 1.6 and higher.
With this tool the diagnosing of the set can be done in an interactive way. In the tool also the adjustment
procedure has been implemented. This is absolutely necessary in case the CDR MainBoard and/or
(CDR Loader) CDM is disconnected from the matched production combination.
Only designated workshops can perform these repairs.
Please send the complete FW-R88 to the designated workshop.
Table of Contents
