29
English
3140 115 29791
Clock/Timer
View clock
The clock (if it is set) will be shown in standby
mode.
To view the clock in any source mode
(VCD or TUNER for example)
●
Press
CLOCK•TIMER
.
➜
The clock is displayed for a few seconds.
➜
If the clock has not been set, "
--
:
--
" is
displayed.
Clock setting
The clock can be set in either 12-hour or
24-hour mode ("
12
:
00
AM
" or "
00
:
00
", for
example)
1
In standby or view clock mode, press
CLOCK•TIMER once
. In other source mode,
press
CLOCK•TIMER
twice
.
2
Press
PROG
repeatedly to select clock mode.
➜
"
12
:
00
AM
" or "
00
:
00
" starts flashing.
3
Press
à
or
á
on the system repeatedly to set
the hour.
4
Press
í
or
ë
on the system repeatedly to set
the minute.
5
Press
CLOCK•TIMER
again to store the
setting.
➜
The clock starts working.
To exit without storing the setting
●
Press
Ç
on the system.
Notes:
– The clock setting will be cancelled when the
power cord is disconnected or if a power failure
occurs.
– During clock setting, if no button is pressed
within 90 seconds, the system will exit clock setting
mode automatically.
Timer setting
The system can switch on to VCD, TUNER or
TAPE mode automatically at a preset time,
serving as an alarm to wake you up.
IMPORTANT!
– Before setting the timer, ensure that the
clock is set correctly.
– The timer will always be switched on
after it has been set.
– The timer will not start if a recording is in
progress.
– The volume of the timer will increase
gradually from the minimum level to the
last tuned volume level.
1
Press and hold
CLOCK•TIMER
for more than
two seconds
to select timer mode.
➜
"
12
:
00
AM
" or "
00
:
00
" or the last timer
setting starts flashing.
➜
starts flashing.
