26
English
TROUBLESHOOTING
Tape Deck Operation
“
RECORDING ACTIVE
” is
displayed.
• A recording is in progress.
™
Stop the recording or wait until it is
finished.
“
TAPE DUBBING ONLY
” is
displayed.
• Tape dubbing is only possible in tape
mode.
™
Switch to tape mode by pressing TAPE.
Recording or playback cannot occur
or there is a decrease in audio level.
• Dirty tape heads, capstans or pressure
rollers.
™
See section on tape deck maintenance.
• Magnetic build-up in the record/
playback head.
™
Use demagnetizing tape.
General
System does not react when any
button is pressed.
• Electrostatic discharge.
™
Press STANDBY-ON to switch the
system off. Remove the AC power plug
from the wall outlet, then reconnect the
power plug and switch on the system
again.
No or poor sound.
• Volume is not turned up.
™
Adjust the volume.
• The headphones are connected.
™
Disconnect the headphones.
• Speakers are not connected or are
connected wrongly.
™
Check that the speakers are connected
correctly.
™
Make sure the stripped speaker wire is
clamped.
Reversed left and right sound.
• Speakers are connected wrongly.
™
Check the speaker connections and
location.
Lack of bass sound or apparently
imprecise physical location of musical
instruments.
• Speakers are connected wrongly.
™
Check the speaker connection for
proper phasing, red/black wires to red/
black terminals.
Remote control has no effect on the
system.
• Wrong source is selected.
™
Select the source (CD, TUNER, etc.)
before pressing the function button,
(
É
,
í
,
ë
, etc.).
• The distance to the system is too large.
™
Reduce the distance.
• Batteries are inserted incorrectly.
™
Insert the batteries with their polarities
(+/– signs) as indicated.
• Batteries are exhausted.
™
Replace the batteries.
Timer is not working.
• Clock is not set.
™
Set the clock.
• Timer is not switched on.
™
Press CLOCK/TIMER to switch on the
timer.
• Dubbing/recording is in progress.
™
Stop dubbing/recording.
Clock setting is erased.
• There was a power failure.
™
Reset the clock.
System displays features
automatically; buttons flash
continuously.
• Demonstration mode is switched on.
™
Press and hold
Ç
(on the system) for 5
seconds to switch off the
demonstration.
All lighted buttons are not lit.
• Equalizer Display is switched on in NITE
mode.
™
Press JOG to other Equalizer Display.
Summary of Contents for FW748P
Page 1: ...1 mini hifi system 5 speaker dolby pro logic FW748P ...
Page 4: ...4 ...
