troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Consumer Care Centre in your
country.
Problem
Possible cause
Solution
The iron is
plugged in,
but the
soleplate
stays cold.
There is a
connection
problem.
Check the mains cord, the plug
and the wall socket.
The temperature
dial is set to MIN.
Set the temperature dial to the
required position.
The iron
does not
produce any
steam.
There is not
enough water in
the water tank.
Fill the water tank (see chapter
‘Preparing for use’, section ‘Filling
the water tank).
The steam control
is set to position 0. Set the steam control to
l
or
;
(see chapter ‘Preparing for use’,
table ‘ Temperature and steam
settings’).
The iron is not hot
enough and/or the
drip-stop function
has been activated.
Set an ironing temperature that is
suitable for steam ironing (
2
to
MAX). Put the iron on its heel and
wait until the temperature light
goes out before you start ironing.
EnGliSh
15
Summary of Contents for GC3600 Series
