14
ENGLISH
4
When you put down the iron during ironing, put it on the
iron platform or place it on the ironing board in horizontal
position, on its soleplate.
Hot steam is emitted from the iron. Never attempt to remove
wrinkles from a garment while someone is wearing it. Do
not apply steam near your or someone else’s body to prevent
burns.
Note: Regularly water is pumped into the boiler inside the
appliance again, which causes the appliance to produce a
pumping sound. This is normal.
ECO mode
During ironing, you can use the ECO mode to save energy but
still have sufficient steam to iron all your garments.
Note: For the best results, we advise you to use the normal
steam mode.
1
Press the ECO button.
,
The ECO button lights up green.
2
To switch back to the normal steam mode, press the ECO
button again.
,
The green light in the ECO button goes out.
TURBO steam mode
The TURBO steam mode has a higher amount of steam. You can
use it for thick garments to have better steam penetration.
Note: As the TURBO steam mode produces a high amount of
steam, the supply hose may become hotter than at the normal
steam and ECO modes. This is normal.
1
Press and hold the on/off button for 2 seconds until the
light turns white.
,
The ‘iron ready’ light on the iron and the white TURBO
light in the on/off button start to flash to indicate that the
iron is heating up to the TURBO steam mode. This takes up
to 2 minutes.
2
To switch back to the normal steam mode, press and hold
the on/off button for 2 seconds until the light turns blue
again.
2 sec.
