Ironing
J
H
I
D
T
M
U
V
T
Steam activator
U
Iron power-on button with light
V
Blowing/suction button
D
Air vent slide
I
Height adjustment lever
H
Board tilting button
J
Locking strap
M
Mains plug
Put the mains plug
M
in an earthed
wall socket. The power-on light goes on.
Fill the water tank.
You can use normal tap water.
1
5
4
1
E
Ironing tips and tricks
•
To iron shirts, use the wide end of the board to save time and energy.
•
To avoid shine and seam imprints, use the blowing mode. To hold the garment flat on the board, use the suction mode.
Undo the locking strap
J
and unfold
the ironing board to vertical position.
Set both air vent slides
D
to the
ironing position.
Push the board tilting button
H
and tilt
the board to horizontal position.
Set the ironing board to the
appropriate height with the height
adjustment lever
I
.
Take the iron out of the iron
compartment, either from the left or
right side.
Press the iron power-on button
U
to
switch on the iron. The power-on light
goes on.
After approx. 2 minutes the iron is
ready for use.
If you want to iron with steam, set the
temperature dial of the iron to
2
or
higher and press the steam activator
T
.
Never direct the steam at people.
Note:
When the temperature dial of
the iron is set below
2
, no steam is
produced, because the iron is not hot
enough.
If you want to iron in the board blowing
mode, press the blowing button on the
iron.
If you want to iron in the suction mode,
press the suction button on the iron.
Note:
To switch off the blowing or suction
function, press the same button again.
You can safely put down the hot iron on
the board cover during ironing.
You can store the hot iron in the
heat-resistant storage compartment
immediately after you have switched
off the iron.
2
3
6
7
8
