1.0 TECHNICAL SPECIFICATION and SERVICE HINTS
seconds and then start up as usual.
14. Connect the device with PC by normal USB
cable again for MTP connection. Select “Take
no action” once the device is detected by the
PC.
15. Run the
MTP_FactoryDM.bat
from
DM
folder to
copy all necessary files into the device.
16. Once the installation is completed, below
dialogue box will auto close.
MTP mode installation procedure
after replaced the mainboard
Note: Applicable for HDD085/HDD082 only
Repeat the recovery procedure for flash corrupt
problem from step 9 to 16.