HB558/A HB558/B
2-7
HINTS FOR REPAIRS
CANOPY
Replacement of lamps/starters (items 2, 42 and 7)
Loosen the screws (item 25) and remove the end covers
(item 12).
Pull the acrylic sheet (item 43) out of the appliance.
Now the lamps/starters can be replaced.
Disassembly of gas spring (item 26)
Fold the canopy up and have a second person lock it in this
position.
Undo two nuts on either side and take the gas spring out of
the hinged parts.
Disassembly of fan (item 20)
Unlock the clamps of the fan cover (item 21).
Loosen the connecting wires and pull out the fan unit
(item 20).
Disassembly of timer (item 32)
Remove the end cover on the side where the timer is
located.
Pull the top cover on this side out of the groove of the side
panel (item 33).
Pull the side panel off the metal frame to create enough
room to remove the timer.
Disassembly of hinge (items 27, 28 and 29)
Unlock the clamps of the hinge cover with a screwdriver.
Loosen the screw (B).
Ask a second person to depress the locks of the bearing
bush (item 29) with two small screwdrivers.
Position yourself on the other side of the appliance and
press the couch with your foot while pulling the canopy
slightly (approx. 5 mm) towards you to deactivate the lock.
Repeat this procedure at the other hinge.
Now you and the other person should position yourselves
at opposite ends of the appliance. Lift the canopy from the
stand by pulling at it.
Place the canopy on a soft surface.
Remove the lock spring (item 28)
Tap the bearing bush off the shaft with a plastic hammer.
- Interchange starters, lamps or ballasts to establish
whether they are defective.
- If they are not defective, check the internal wiring,
especially that connected to the lamp holders.
- The snap-on connections of the wiring can be detached
by means of a paperclip.
- Premature blackening of a tube end points to a defective
starter or a wiring fault.
- A burned NTC resistor or overheated wiring points to a
wiring fault at the connecting block.
- The acrylic sheets can be cleaned with a moist cloth and
some washing-up liquid.
Avoid the use of alcohol, alcohol-based cleaners, petrol,
acetone or abrasives.
These substances can cause irreparable damage to the
sheets.
Disassembly of facial unit (item 37)
Remove the fan, the end covers and the top cover.
Contrary to what is indicated in the exploded view, a
complete refl ector unit with fi lter glass mounted in a metal
frame is supplied as item 37.
COUCH
Replacement of lamps and starters (items 2 and 7)
Loosen the screws and remove the end covers (item 12).
Pull the acrylic sheet (item 1) out of the appliance.
Now the lamps/starters can be replaced.
Disassembly of fan (item 20)
Remove the side panels of the decorative cover (item 13).
Put the canopy in its highest position.
Turn the appliance on its back with help of a second person.
Unlock the clamps of the fan cover (item 21).
Loosen the connecting wires and pull out the fan unit
(item 20).