HD7817/40 /41 /42
2-7
Disassembly information
To remove the brew chamber lid cover handle as follows:
•
Place the screwdriver on the
positions (see picture 1) and
lift the cover over the snap
locks on both positions.
•
The cover lid can now be
lifted up a little and to
remove the complete cover
including lever and push rod
squeeze strongly with two
fingers both legs of the push
rod (see picture 2) to each
other, so that the two pins will
get out of the hinge position
on the brew chamber.
•
To remove lever from lid cover, take a screwdriver and
bend carefully the two lips/ribs in the lid cover outwards
and push the lever with force out of the hinge.
•
Reassemble follow steps backwards, without using a
screwdriver.
To remove the back cover handle as follows:
•
Remove valve outlet.
•
Start at the upper side of the back cover and stick a
screwdriver into the 2 snap locks positions and gently
pull the back cover from the appliance so that a little
chink between back cover and brew chamber becomes
visible.
•
Put the screwdriver in to the 4 rectangular holes (snap
locks) at the back and gently pull the screwdriver such
away that the lips of the snap locks are bent outwards.
•
If all clicks positions are loose, it is possible to remove the
back cover.
•
Reassemble follow steps backwards.
picture 1
picture 2
Removing Brew chamber head handle as follows:
•
Disassemble back cover!
•
Place the appliance such a way that you are looking at
the boiler.
•
First remove the boiler from the snap lock position of the
brew chamber.
•
To remove the brew chamber,
use your both thumbs (see
picture 3) and push strongly
with a little distortion
(rotation) until the brew
chamber comes loose.
•
Reassemble follow above steps backwards.
To reach the components placed on the base handle as
follows:
•
First remove back cover, brew chamber and 3-way valve.
•
Remove both Torx T15 screws see exploded view in the
near of position
A
.
•
Bend the 2 click snap locks with a screwdriver (see base),
and the housing can now be removed.
•
To remove the rest of the housing unlock the last 4 snap
locks at the base and gently pull of the front cover.
•
To reassemble follow above steps backwards.
picture 3
Disassembly- and reassembly advice
