Important
◗
Check if the voltage indicated on the appliance corresponds to
the local mains voltage before you connect the appliance.
◗
Keep this appliance away from water! Do not use this product
near or over water contained in baths, washbasins, sinks etc.
When used in a bathroom, unplug the appliance after use since
the proximity of water presents a risk, even when the hairdryer is
switched off.
◗
For additional protection, we advise you to install a residual
current device (RCD) with a rated residual operating current
not exceeding 30mA in the electrical circuit supplying the
bathroom.Ask your installer for advice.
◗
Keep the appliance out of the reach of children.
◗
Never block the air grilles.
◗
If the appliance overheats, it will switch off automatically. Unplug
the appliance and let it cool down for a few minutes. Before you
switch the appliance on again, check the grilles to make sure they
are not blocked by fluff, hair, etc.
◗
Always switch the appliance off before putting it down, even if it
is only for a moment.
◗
Noiselevel: L= 86 dB(A) re 1pW
Using the appliance
Drying
1
Put the plug in the wall socket.
2
Switch the appliance on by setting the airflow slide to position I, II
or III.
3
Select the desired airflow speed by setting the airflow slide to
position I, II or III. (fig. 1)
O = Off
I = Low airflow especially intended for styling
II = Medium airflow for drying and styling
III = Ultra strong airflow for fast drying
ENGLISH
7
Summary of Contents for HP4879/00
