-
general
: Make sure your skin is clean and free from grease. Do not
apply any cream to your skin before you start to epilate.
-
general
: We advise you to epilate before you go to bed at night, as
skin irritation usually disappears overnight.
-
general
: Epilation is easier and more comfortable when the hairs
have a length of 3-4 mm. If the hairs are longer, we recommend that
you shave first and epilate the shorter regrowing hairs after 1 or 2
weeks.
Epilating
Note: If you are new to epilation, start epilating with the double wavy massage
attachment to minimise the pulling sensation of epilation. This attachment is
only intended for epilating the legs.
Note: To epilate the underarms or bikini line, use the sensitive area cap that
reduces the number of active epilating discs.
1
Put the attachment on the epilating head.
2
Press the on/off button once to switch on the appliance.
,
The appliance starts to operate at speed II, which is the most
efficient speed for epilating.
Note: If you want to use speed I, press the on/off button a second time. Speed
I is suitable for areas with little hair growth, for hard-to-reach areas and for
areas where bones are located directly beneath the skin, such as knees and
ankles.
3
Stretch the skin with your free hand to make the hairs stand upright.
Place the epilating head at an angle of 90° onto the skin with the on/
off button pointing in the direction in which you are going to move
the appliance.
- Epilate your bikini line as shown in the figure.
- Epilate your underarms as shown in the figure.
4
Move the appliance slowly over the skin against the direction of the
hair growth while pressing it lightly.
5
Press the on/off button a third time to switch off the appliance.
EnglisH
9
Summary of Contents for HP6521
