Philips HR2004, Manual

6

introduction

Congratulations on your purchase and welcome to Philips! To fully benefit from the support that 

Philips offers, register your product at www.philips.com/welcome.

important

Read this user manual carefully before you use the appliance and save it for future reference.

Noise level: Lc = 86 dB(A)

general
Danger

 - Never immerse the motor unit in water or any other liquid, nor rinse it under the tap. Use only 

a moist cloth to clean the motor unit.

Warning

 - Check if the voltage indicated on the appliance corresponds to the local mains voltage before 

you connect the appliance.

 - If the mains cord is damaged, you must have it replaced by Philips, a service centre authorised by 

Philips or similarly qualified persons in order to avoid a hazard.

 - Do not use the appliance if the plug, the mains cord or other parts are damaged.

 - Never use the blender jar or mill beaker (specific types only) to switch the appliance on and off.

 - Never let the appliance run unattended.

 - This appliance is not intended for use by persons (including children) with reduced physical, 

sensory or mental capabilities, or lack of experience and knowledge, unless they have been given 

supervision or instruction concerning use of the appliance by a person responsible for their safety.

 - Children should be supervised to ensure that they do not play with the appliance.

 - Do not touch the blades, especially when the appliance is plugged in. The blades are very sharp.

 - If the blades get stuck, unplug the appliance before you remove the ingredients that block  

the blades.

 - Never place the blade unit onto the motor unit if the blender jar or mill beaker (specific  

types only) is not or not properly attached to it.

Caution

 - Always unplug the appliance before you assemble, disassemble or make adjustments to any of 

the parts.

 - Never use any accessories or parts from other manufacturers or that Philips does 

not specifically recommend. If you use such accessories or parts, your guarantee becomes 

invalid.

 - If you have not finished processing after the standard processing time, switch off the 

appliance and let it cool down for about 10 minutes before you process the next batch. If you 

need to process more than 5 batches, let the appliance cool down to room temperature for 

about 90 minutes after 5 batches before you let the appliance operate again. This helps prolong 

the life of the appliance. 

Blender
Warning

 - Never reach into the blender jar with your fingers or an object while the appliance is running.

 - Make sure the blade unit is securely fastened to the blender jar before you assemble the 

blender jar onto the motor unit.

 - Do not touch the cutting edges of the blade unit when you clean it. They are very sharp and 

you could easily cut your fingers on them.

EnglisH