20
EN
Note
•
AM and digital radio are not supported.
•
If no stereo signal is detected, you are prompted to
install the radio stations again.
1
Connect the FM antenna to the
FM
ANTENNA
on your home theater.
•
For the best reception, place the
antenna away from your TV or other
sources of radiation.
2
Press
SOURCE
repeatedly to switch to
radio source.
»
If you have already installed the radio
stations, the last channel that you
listened to is played.
»
If you have not installed any radio
stations, the message
AUTO
INSTALL...PRESS PLAY
appears on
the display panel. Press (
Play
) to
install radio stations.
3
Use the remote control to listen or to
change radio stations.
Play buttons
Button
Action
/
or
Alphanumeric
buttons
Select a preset radio
station.
Navigation buttons
Left/Right: Search for a
radio station.
Up/Down: Fine tune a
radio frequency.
Press to stop the
installation of radio
stations.
Press and hold to erase
the preset radio station.
Button
Action
Manual:
1) Press .
2) Press / to select
your preset.
3) Press again to store
the radio station.
Automatic: Press and
hold for three seconds
to reinstall the radio
stations.
SUBTITLE
/
AUDIO
Toggle between the
stereo and mono sounds.
Tuning grid
In some countries, you can toggle the FM tuning
grid between 50 kHz and 100 kHz.
1
Press
SOURCE
repeatedly to switch to
radio source.
2
Press .
3
Press and hold (
Play
) to toggle between
50 kHz or 100 kHz.
External audio device
Connect an external audio device to play audio
files.
What you need
•
An external audio device with 3.5mm jack.
•
A 3.5mm stereo audio cable.
1
Using the 3.5mm stereo audio cable,
connect the external audio device to
AUDIO IN
the connector on your home
theater.
2
Press
SOURCE
repeatedly until
AUDIO
IN
appears on the display panel.
3
Press the buttons on the external audio
device to select and play audio files.
Summary of Contents for HTB5520
Page 2: ......
