20
EN
5
Press again to stop music.
Note
•
Make sure that the picture and audio formats are
supported by your home theater (see 'File formats' on
page 33).
Radio
Listen to FM radio on your home theater, and
store up to 40 radio stations.
Note
•
AM and digital radio are not supported.
•
If no stereo signal is detected, you are prompted to
install the radio stations again.
1
Connect the FM antenna to the
ANTENNA FM 75
on your home
theater.
•
For the best reception, place the
antenna away from your TV or other
sources of radiation.
2
Press (
Home
).
3
Select
[Radio]
, and then press
OK
.
4
Select
[FM Radio]
, and then press
OK
.
»
If you have already installed the radio
stations, the last channel that you
listened to is played.
»
If you have not installed any radio
stations, follow the message displayed
on the screen to install radio stations.
5
Use the remote control to listen or to
change radio stations.
•
You may also follow onscreen
instructions for radio operation.
Play buttons
Button
Action
/
or
Alphanumeric
buttons
Select a preset radio station.
Navigation
buttons
Left/Right: Search for a radio
station.
Up/Down: Fine tune a radio
frequency.
Press to stop the installation
of radio stations.
BACK
Exit the radio mode.
SUBTITLE
Toggle between the stereo
and mono sounds.
Tuning grid
In some countries, you can toggle the FM tuning
grid between 50 kHz and 100 kHz. When you
switch the tuning grid, all preset radio stations
are erased.
1
Press (
Home
).
2
Select
[FM Radio]
, and then press
OK
.
3
Press and hold (
Play
) to toggle between
50 kHz or 100 kHz.
MP3 player
Connect a MP3 player to play audio files.
What you need
•
An MP3 player.
•
A 3.5mm stereo audio cable.
1
Using the 3.5mm stereo audio cable,
connect the MP3 player to the
AUDIO IN
connector on your home theater.
•
If you use 6.5mm stereo audio cable,
connect the MP3 player to your
home theater using a 3.5mm - 6.5mm
converter jack.
Summary of Contents for HTB9225D
Page 2: ......
