23
EN
8 Troubleshooting
Warning
•
Risk of electric shock. Never remove the casing of the
product.
To keep the warranty valid, never try to repair
the product yourself.
If you have problems using this product, check
the following points before you request service.
If you still have a problem, get support at
www.philips.com/support.
Main unit
The buttons on the home theater do not
work.
•
Disconnect the home theater from the
power supply for a few minutes, then
reconnect.
Picture
No picture.
•
Make sure that the TV is switched to the
correct source for the home theater.
No picture on a TV connected through HDMI.
•
Make sure that the HDMI cable is not
faulty. If it is faulty, replace it with a new
cable.
•
Wait for 10 seconds for auto recovery,
or change the HDMI video setting (see
'Picture and video settings' on page 18).
Disc does not play high-definition video.
•
Make sure that the disc contains high-
definition video.
•
Make sure that the TV supports high-
definition video.
•
Use an HDMI cable to connect to the TV.
Sound
No sound from home theater speakers.
•
Connect the audio cable from your home
theater to your TV or other devices.
However, you do not need a separate
audio connection when the home theater
and TV are connected through an
HDMI
ARC
connection.
•
Set up the audio for the connected device
(see 'Set up the audio' on page 10).
•
Reset your home theater to its factory
settings (see 'Restore default settings' on
page 19), and then switch it off and switch
on again.
•
On your home theater, press
SOURCE
repeatedly to select the correct audio
input.
Distorted sound or echo.
•
If you play audio from the TV through the
home theater, make sure that the TV is
muted.
Audio and video are not synchronized.
•
1) Press and hold
AUDIO SYNC
.
2) Press the
Navigation buttons
(left/right)
within five seconds to synchronize the
audio with the video.
Play
Cannot play a disc.
•
Clean the disc.
•
Make sure that the home theater supports
the type of disc (see 'Media formats' on
•
Make sure that the home theater supports
the region code of the disc.
•
If the disc is a DVD±RW or DVD±R disc,
make sure that it is finalized.
Cannot play a DivX file.
• Make sure that the DivX file is encoded
according to the 'Home Theater Profile'
with the DivX encoder.
• Make sure that the DivX file is complete.
