12
EN
Bluetooth
•
Bluetooth profiles: A2DP, AVRCP
•
Bluetooth version: 2.1 + EDR
Main unit
•
Power supply: 120 V~, 60 Hz
•
Power consumption: 25 W
•
Standby power consumption: ≤ 0.5 W
• Speaker impedance: 4 ohm (full range)
• Speaker drivers: 4 x 54.5 mm (2")
•
Dimensions (W x H x D):
865 x 67.8 x 85.5 mm (34.1" x 2.7" x 3.4")
•
Weight: 1.8 kg / 3.96 lbs
Remote control batteries
• 1 x AAA-R03-1.5 V
7 Troubleshooting
Warning
•
Risk of electric shock. Never remove the casing of the
product.
To keep the warranty valid, never try to repair
the product yourself.
If you have problems using this product, check
the following points before you request service.
If you still have a problem, get support at
www.philips.com/support.
Main unit
The buttons on the SoundBar do not work.
• Disconnect the SoundBar from the power
supply for a few minutes, then reconnect.
Sound
No sound from SoundBar speakers.
• Connect the audio cable from your
SoundBar to your TV or other devices.
• Reset your SoundBar to its factory settings.
• On the remote control, select the correct
audio input.
• Make sure that the SoundBar is not muted.
Distorted sound or echo.
• If you play audio from the TV through the
SoundBar, make sure that the TV is muted.
Bluetooth
A device cannot connect with the SoundBar.
• The device does not support the
compatible profiles required for the
SoundBar.
• You have not enabled the Bluetooth
function of the device. See the user manual
of the device on how to enable the
function.
