33
[Speakers Delay]
Sets the delay time for the center and rear
speakers if they are placed closer to the
listening position, so that the sound output
from all speakers reach the listening position
at the same time.
1) To start, press
OK
.
2) Select a speaker in the menu, then press
to set the delay time.
3) Press
OK
to confi rm and exit.
Note
Allow 1ms setting for every 1 foot distance
•
between the speaker and the listening position.
[HDMI Audio]
Selects the HDMI audio setting when you
connect this Home Theater System and the
TV with a HDMI cable.
•
[On]
– Allows audio output through the
TV and the speaker system. If the audio
format on the disc is not supported, it
will be downmixed to two-channel sound
(linear-PCM).
•
[Off]
– Disables audio output from the
TV. The sound is only output through the
speaker system.
[CD Upsampling]
Converts the music CD to a higher sampling
rate using sophisticated digital signal
processing for better sound quality.
•
[Off]
– Disables CD-upsampling.
•
[88.2kHz (X2)]
– Converts the sampling
rate of the CDs twice as high as the
original rate.
Note
CD upsampling is only available in stereo
•
mode.
Audio setup
1
Press
SETUP
.
»
[General Setup]
menu is displayed.
2
Press
to select
[Audio Setup]
, then
press .
3
Select an option, then press
OK
.
4
Select a setting, then press
OK
.
To return to the previous menu,
•
press
BACK
.
To exit the menu, press
•
SETUP
.
Note
See the explanations of the above options in
•
the following pages.
[Speakers Volume]
Sets the volume level of each speaker to get
the ideal audio balance.
1) To start, press
OK
.
2) Select a speaker in the menu, then press
to adjust the volume level.
3) Press
OK
to confi rm and exit.
Note
The test tone is emitted from the speaker
•
which you adjust.
CD Upsampling
Speakers Delay
Speakers Volume
HDMI Audio
Audio Setup
Audio Sync
English
EN
