3 - 2
3 - 2
SERVICE POSITIONS
Service position A
Note:In some service positions the components or copper patterns of one board may risk touching its neighbouring pc boards or
metallic parts. To prevent such short-circuit use a piece of hard paper or other insulating material between them.
Dismantling of the MAIN+SCART Board
1) Loosen 4 screws “G” on the top of Main Board as shown in fi gure 11.
2) Loosen 11 screws at the back panel as shown in fi gure 12.
Figure 9
Dismantling of the DISP+LED+VOL&MP3 IN Board
1) Loosen 10 screws “E” on the top of DISP+LED+VOL&MP3 IN Board as shown in fi gure 8.
Figure 8
E
Dismantling of the Power Board
1) Loosen 4 screws “F” on the top of Power Board as shown in fi gure 9.
2) With a pincers to nip this space as shown in fi gurer 10 and to take up the power board.
F
Figure 11
G
Figure 12
Figure 10
Summary of Contents for HTS3371/94
