Philips HTS3376, Service Manual

2 - 1

2 - 1

System , Region Code , etc. Setting Produre

1)System Reset

a) Press “SETUP“ button on R/C,TV will show setup menu

b) Select the menu using the    and   on R/C

c) Go preference page to do system reset

2)Region Code Change

a) In open mode, press”9” “9“ “9“ “9“ on R/C,then input desired 

number to change region code :

                                1           USA

                                2           EU

                                3           AP

                                4           Australia ,NZ , Latam

                                5           Russia , INDIA

                                6           CHINA

3)Version Control Change

a) In open mode, press “1“ “5“ “9“ on R/C

b) Press “ok” button to confi rm

c) TV will show message as below:

7) Upgrading new software

a) Copy “software fi les” into a CD-R

b) Open the CD Door,then insert the CD-R program disc 

c) Close the CD Door

d) VFD will show:

                        “Loading“

                        “Erase” -- erase the fl ash memory                      

                        “Writing” about 1 minute

                        “done “                       

   * the system will switch off and on again automatically.

e) OSD will show:

              Current model             

HTS3377/12/05

              Version: XX.XX.XX         Release:XXXX.XX.XX

               region 

:2

                        Servo:XX.XX.XX.XX              

               8032:XX.XX.XX.XX       RISC: XX.XX.XX.XX       

               MCU:XX.XX        

   If current model does not match you set use down arrow 

key on the remote to change

                                       OK

   CAUTION!

 This information is confi dential and may not be 
distributed.Only a qualifi ed service person should 
reprogram the Region Code.

4)Password Change

a) Press “SETUP“ button on R/C,TV will  show setup menu

b) Select the menu using the    and   on R/C

c) Go preference page select “password“ to change 

* 000000 is default password supplied.

5)Check on the Software Version

a) Open the CD Door

b) Press “INFO“ button on R/C 

c) TV will show the version on screen

upgrade fi le detected

Do you wish to continue with

the software upgrade?

OK

Cancel

f) Select “OK”, OSD will show:

upgrade in progress...

V337X

please do not unplug or

switch off the device.

6)Trade model

a) Press “Open/Close “ button on R/C

b) Press “2” “5” “9” on R/C,VFD will display “TRA ON “ or “TRA 

OFF“