Philips HTS5220, Service Manual

2 - 2

2 - 2

      Software upgrade will take 5 minutes

               Do not switch off!

           Package version:      000034.0

Software BE             Completed

Software FE             Completed

Software MCU1:       Not started

Software Dock:         2%

Software MCU3:       Not started 

      Software upgrade will take 5 minutes

               Do not switch off!

           Package version:      000034.0

Software BE             Completed

Software FE             Completed

Software MCU1:       1%

Software Dock:        Failed

Software MCU3:        

f) The set will shut down automatically when the software upgrade 
is completed.

6)How to replace the defective Blu-ray Loader

a) Remove the defective Blu-ray Loader.

b) loosen the short circuit socket and remove it  as shown follow:

note: 1.the short circuit socket connect 45p VFC cable on the BD 

Loader ;2.the socket make the ESD protection points short circuit.

c) Assembly Blu-ray Loader to “J802”,”J900”,”J906” on the top of 

BD Board as shown below.

7)BD board and Blu-ray Loader OPU matching procedure

Note: This procedure must be performed whenever the defective 

Blu-ray Loader or BD Board has been replaced .

a) Loosen the short circuit socket and remove it  

b) Assembly Blu-ray Loader to BD Board.

c) Power on the set , press “

” <Home> button and input  “5” “1” 

“7” “7” on R/C.

d) Go into OSD Select mode and select item [5] ,then press <OK> 

button on R/C as shown follow:

e) Insert empty USB device of MSC type and press <OK> button 

with R/C as shown follow:

f) Using 

 “    

” 

buttons on R/C input the 6-digits OPU data 

given on the 1D barcode (see label on the Loader) with the on-

screen selection and press <OK> button to save each digit entered

 
as shown follow:
        

g) Press <Back> followed by <OK> button to fi nish OPU matching

 and  “

”<Home> button to exit.

h) Repeat step c) and select item [6] ,then press <OK> button on

R/C as shown follow:

i)

Wait laser check to complete,press <stop> button to exit as

shown follow:

j) If laser check fails press “

” <Home> button and repeat OPU 

matching procedure.

123412

   CAUTION!

 This information is confi dential and may not be 
distributed.Only a qualifi ed service person should 
reprogram the Region Code.

J802

J900

J906

8) Produce to change Tuner grid(only for /98/51 version)

In some countries, you can switch the FM tuning grid between 50 

kHz and 100 kHz. Changing the tuning grid erases all preset radio 

stations.

a) Press<radio> button on R/C 

b) Press <Stop> button on R/C.

c) Press and hold <Play> until (50 kHz) or (100 kHz) is displayed. 

Note: repeaing the same action will toggle back to it  previous 

tunning grid setting.

9) Menu Language setup (only for 51 version)

a) Press “

” <Home> button on R/C.

b) Select <SETUP>, then press “OK” button on R/C.

c) Select <preference setup>, then press <OK> button on R/C.

d) Select <Menu language>, then press <OK> button on R/C.

C) Select <English>, then press <OK> button on R/C.