English
EN
35
Pl
ay
Listen to radio
1
Press
RADIO
repeatedly to select ‘FM’ or
‘AM/MW’ band.
2
Use the remote control to control the
radio.
Button
Action
Select a preset radio station.
m M
Tune the radio frequency
backward/ forward.
Toggle between FM stereo
and FM mono mode.
Press and hold this button to
delete the preset station from
the preset list.
The preset number for
other radio stations
remain unchanged
•
Reinstall all the radio stations
1
Press
RADIO
repeatedly to select ‘FM’ or
‘AM/MW’ band.
2
Press and hold
PROGRAM
until
‘STARTING INSTALL’ is displayed.
All previously stored radio stations will
be replaced.
Note
If no stereo signal is detected or less than 5 stations
are detected during radio installation, ‘CHECK
ANTENNA’ is displayed.
•
Search and store radio stations
individually
1
Press
RADIO
repeatedly to select ‘FM’ or
‘AM/MW’ band.
2
Press
m
M
.
The radio frequency indication starts to
change until a radio station is detected.
3
Repeat step 2 until you tune to the radio
station you wish to store.
To
fi
netune the radio frequency, press
vV
.
4
Press
PROGRAM
.
If no action is carried out within 20
seconds after the above step, it exits
the preset mode.
5
Press
í
ë
(or the
number buttons
) to
select a preset number to store.
6
Press
PROGRAM
to con
fi
rm.
Change tuning grid
In some countries, the frequency step between
adjacent channels in FM band is 50 kHz or
100 kHz (AM/MW band is 9 kHz or 10 kHz).
Note
This feature only applicable for certain region.
Change tuning grid erases all preset radio stations.
•
•
1
Press
RADIO
repeatedly to select ‘FM’ or
‘AM/MW’ band.
2
Press
x
.
3
Press and hold
u
until ‘GRID 9’ or
‘GRID 10’ is displayed.
‘GRID 9’ for FM 50 kHz (or AM 9 kHz)
and ‘GRID 10’ for FM 100 kHz (or AM
10 kHz).
•
•
•
Summary of Contents for HTS6100
Page 52: ...52 ...
Page 53: ...53 ...
Page 54: ... 2008 Philips Consumer Lifestyle All right reserved sgpjp 0821 75 1 ...
