2 -
2 -
System , Region Code , etc. Setting Produre
1)System Reset
a) Press “SETUP“ button on R/C,TV will show setup menu.
b) Select the menu using the and on R/C.
c) Go preference page to do system reset.
2)Region Code Change
a) In open mode, press”9” “9“ “9“ “9“ “9“on R/C,then input desired
number to change region code :
USA
2 EU
3 AP
4 Australia ,NZ , Latam
5 Russia , INDIA
6 CHINA
3)Version Control Change
a) In open mode, press ““ “5“ “9“ on R/C.
b) Press “ok” button to confirm.
c) TV will show message as below:
8) Upgrading new software
a) Copy “software files” into CD-R or USB.
b) Insert CD-R or put USB into USB jack.
c) Press “DISC“ or “USB“ button on R/C.
d) VFD will show:
“LOADING CONTENTS“
pop messange “upgrading“
“Writing” about minute
“done “
e) TV will show:
Current model
HTS6520/55
Release:XXXX.XX.XX Version: XX.XX.XX
Region
:X
Servo:XX.XX.XX.XX
8032:XX.XX.XX.XX RISC: XX.XX.XX.XX
If current model does not match you set, use down arrow
key on the remote to change
OK
4)Password Change
a) Press “SETUP“ button on R/C,TV will show setup menu.
b) Select the menu using the V and B on R/C.
c) Go preference page select “password“ to change.
* 36900 is default password supplied.
5)Check on the Software Version
a) Open the CD Door.
b) Press “INFO“ button on R/C.
c) TV will show the version on screen.
CAUTION!
T
his information is confidential and may not be
distributed.Only a qualified service person should
reprogram the Region Code.
Upgrade file detected
upgrade?
Press OK to start
f) Press “PLAY“, TV will show:
UPGRADING HTS6520
DO NOT POWER DOWN
POWER BOX MCU
PANEL MCU
DVD FLASH
6)Trade model
a) Press “Open/Close “ button on R/C.
b) Press “2” “5” “9” on R/C,VFD will display “TRA ON “ or “TRA
OFF“.
7) Produce to Change Tuner Grid
(only applicable for certain regions)
In some countries, the frequency step between adjacent channels
in the FM band is 50kHz (00kHz in some areas).
a) Press “source” to select “FM”.
g) After the system will switch off automatically.
b) In “FM” playback mode, press & hold “play/pause” button until
Grid 9” or “Grid 0” appears.
Note: repeating the same action will toggle back to it previous
tuning grid setting.
* “Grid 0” is default for/
55
version.
Summary of Contents for HTS6520/55
