3 - 1
3 - 1
DISASSEMBLY INSTRUCTIONS
24mm
m
m
2
Figure 2
Dismantling of the Top panel
1) Loosen 11 screws to remove the Top Cover .
- 5 screws “A” at the back panel as shown in fi gure 1.
- 6 screwS “B” at the bottom panel as shown in fi gure 2.
Figure 1
Dismantling of Blu-ray Loader
1) Loosen 4 screws “ C “ at the Blu-ray Loader as shown in fi gure 6.
Dismantling of the BD Door
1) Open the BD Tray by using the Open/Close Button while the Set is ON and disconnect the mains supply after removing the Tray
Cover.
Note: If this is not possible, the BD Tray has to be open manually.
Take a mini screw driver about 2mm diameter and make a marking 24mm from the tip as shown in fi gure 4 . Place the set on its
side, insert the mini screw driver till the marking and slide it towards the right as shown in fi gure 3 until the Tray moves out of the
Front Panel.
2) Return the set to its upright position and remove the Tray Cover as shown in Figure 5 and close the tray manually by pushing it back
in.
Figure 4
Figure 5
Figure 3
Figure 6
A
B
C
Dismantling of BD Board
1) Loosen 4 screws “D “ on the top of BD Board as shown in fi gure 7.
D
Figure 7