6
Empty the contents of the medication vial into the medication chamber.
• The maximum fill volume is 8ml and this is shown by the word MAX on the protrusion
below the hinge.
Do not fill medication above this level.
Close the lid to the medication chamber.
If using a mask, attach the mask adapter to the mouthpiece assembly
and attach the mask
to mask adapter.
If you are using the power adapter to power the nebulizer, plug the cable into the socket
on the handset and plug the adapter into the wall outlet.
Press the on/off button on the handset to switch the nebulizer on and begin nebulization.
10
Check the battery level.
• If the LED is
SOLID GREEN
the battery is charged.
• If the LED is
SOLID AMBER
, there is enough charge for at least one more treatment.
Please charge your nebulizer after your treatment.
• If the LED
FLASHES AMBER
and then switches off there is not enough charge to take
a treatment.
• If the LED does not illuminate, please refer to the troubleshooting section of this manual.
11
Ensure aerosol is coming out of the mouthpiece or mask.
12
a) If using the mouthpiece,
hold the handset in your hand and place the mouthpiece
between your teeth with your lips sealed around it. Breathe normally through your mouth.
b) If using a mask,
hold the handset in your hand and gently press the mask against your
face and breathe normally through your mouth.
During use, some aerosol will be emitted from the back of the mouthpiece assembly.
Do not tilt the device in any direction more than 45 degrees during the course of
a treatment as this will prevent the nebulizer from completely nebulizing all the
medication in the chamber.
1128271R02_InnoSpireGo_Euro2_Spreads_IFU_10B_FINAL.indd 6
11/8/17 5:07 PM
