DU-PH-0062-60 Rev A 7/16/07 GCX Corp Page 4 of 7
Attaching Fixed Tilt Mount to Roll Stand Post
1. Align three (3) mounting holes in Fixed Tilt Mount with corresponding mounting holes in top of Post and fasten Mount
to Post with three (3) #10 x 3/4'' FHMS as shown below.
Installation Note:
Fixed Tilt Mount must be oriented toward
the intended front of the roll stand as shown below.
2. Remove backing from Lexan Screw Cover and place on top of screw heads as shown below. Procedure is same for
MP2 Mount (shown) or MP5 Mount.
3. Not shown. Align Basket and Handle with the Fixed Tilt Mount orientation and tighten mounting screws as required to
secure Basket and Handle on the Post.
#10-32 x 3/4'' FHMS (3)
MP5 Fixed Tilt Mount
MP2 Fixed Tilt Mount
#10-32 x 3/4'' FHMS (3)
Roll Stand Front
Roll Stand Front
Screw Cover
