DU-PH-0062-60 Rev A 7/16/07 GCX Corp Page 7 of 7
Cable Management (MP2 Only)
Two (2) Cable Clips are provided for managing cables along Roll Stand Post. Place loose cables inside Clip and slide Clip
onto Post as shown.
Routine Maintenance
Periodically check all mounting hardware. Tighten as necessary for optimal operation and safety.
Cleaning the Mounting Assembly
CAUTION:
GCX makes no claims regarding the efficacy of the listed chemicals or processes as a means for controlling
infection. Consult your hospital’s infection control officer or epidemiologist. To clean or sterilize mounted instruments or
accessory equipment, refer to the specific instructions delivered with those products.
1. The mounting assembly may be cleaned with most mild, non-abrasive solutions commonly used in the hospital
environment (e.g. diluted bleach, ammonia, or alcohol solutions).
2. The surface finish will be permanently damaged by strong chemicals and solvents such as acetone and
trichloroethylene.
3. Do not use steel wool or other abrasive material to clean the mounting assembly.
4. Damage caused by the use of unapproved substances or processes will not be covered by warranty. We
recommended that you test any cleaning solution on a small area of the mounting assembly that is not visible to verify
compatibility.
5. Never submerge or allow liquids to enter the mounting assembly. Wipe any cleaning agents off the mounting assembly
immediately, using a water-dampened cloth. Dry all mounting assemblies thoroughly after cleaning.
Cable Clip
Cable Clips (2)
Cables
Slide onto Post
Cable Clip
