Changing the Configuration Set
Setting up your Monitor 3-53
S
e
tt
ing up y
our
M
onit
o
r
Changing the Configuration Set
If you want to change the application of your system, for example, from
Configuration Set 1 adult to Configuration Set 3 neonatal, you can do this
in monitoring mode by getting into the Monitor Setup setup. This
procedure will not
modify
a Configuration Set, but will change
completely from one Configuration Set to another.
Note—
Changing the Configuration Set causes all the monitor's settings to
revert automatically to user default settings. All patient data is lost.
Note—
If you are using the ACMS, you will not have a choice of “Unit
Type”, as this is automatically set to OR.
Note—
If you do not want to store the default settings in the plug-in
modules, do one of the following:
Monitor Setup
Adult/Pedi/Neo
Change ConfSet
Summary of Contents for M1165
